Latest Products
-
WALBRO MOTORSPORT E85 FUEL PUMP - 450 L/H
€ 182.00 TAX included
-
ALPHA COMPETITION INLET HOSE FOR AUDI S3 8V / TT 8S / GOLF 7 GTI / R / LEON 5F CUPRA
€ 64.99 TAX included
-
RM MOTORS TRANSVERSE STRAIGHT-THROUGH SUPER FLOW PERFORMANCE MUFFLER
€ 219.00 – € 227.80 TAX included
-
WATER PUMP, ENGINE COOLING THERMAL MANAGEMENT MODULE FOR AUDI S3 8V / TT 8S / GOLF 7 GTI / GOLF 7 R / LEON 5F CUPRA 1.8/2.0 TSI EA888.3 MQB
€ 350.00 TAX included
-
TIMING CHAIN KIT FOR 2.0 TFSI EA113
€ 130.00 TAX included
-
- Street Comfort
Products to improve driving and operating comfort - Street Performance
Coilovers for an individual look and to improve driving dynamics on the road - Track Performance
Clubsport & racing suspensions to achieve the fastest possible lap time
For quotation please fill the budget form on our webshop.
- Street Comfort
-
ST Coilover Kits enable you to individually adjust the ride height of your car to improve the appearance and driving behavior. Depending on your selection, ST coilover kits offer a wide range of adjustments giving you the tools needed to dial them in to your requirements.
For quotation please fill the budget form on our webshop.
-
ap coilover kits offer the possibility to adjust drivers the desired lowering accurate to a millimeter for the sporty ambitioned driver. ap offer sporty handling and ideal performance in combination with the maximium lowering.
For quotation please fill the budget form on our webshop.
-
Length: 100mm
Aplication: Radiator / Coolant / Air / Water
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC -
Length: 1000mm
Aplication: Vaccum Lines & Coolant Overflow
Reinforcement: None
Temperature Rated: -60ºC to +180ºC
Material: Peroxide Cured 70 Shore Silicone -
Length: 100mm
Aplication: Radiator / Coolant / Air Hose / Water
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC -
Length: 100mm
Aplication: Radiator / Coolant / Air Hose / Water
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC -
Length: 100mm
Aplication: Radiator / Coolant / Air Hose
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC -
Internal Diameter: 60mm
Length: 100mm
Aplication: Radiator / Coolant / Air Hose
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
70mm to 51mm
Length: 100mm
Aplication: Radiator / Coolant / Air Hose / Water
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC -
Length: 100mm
Aplication: Radiator / Coolant / Air Hose / Water
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC -
BMC Complete Washing Kit
(Detergent + Spray)
-
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
This sensor is used to measure air pressure within the boost pipes of your engine, as well as measuring the air temperature
-
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
– Direct bolt on
– Built in micro cat
– 100% stainless steel
– Compatible with any O2 sensors
– 90° bent structure for better access -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
Over time EGR system in your vehicle can become blocked with tar and sediment which affects economy and performance. This EGR Kit is a direct and simple replacement which solves those problems.
-
Sabelt seat sliding runners are made to fit Sabelt and Sparco seats directly and to allow sliding movement backwards and forwards.
-
Reduce temperatures!
- Thermal insulation of manifold/exhaust components
- Reduces engine bay temperature
- 15m x 50mm width (1.6mm thick)
- Material : titanium finish fiberglass
-
Over time EGR system in your vehicle can become blocked with tar and sediment which affects economy and performance. The EGR Kit is a direct and simple replacement which solves those problems.
-
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
Technical features
- Panel
- Outside Width 133mm
- Outside Length 342mm
-
Installed high: 25,5 mm
Valve lift: 11,0mm
Hardness kp: 80 -
Technical Information:
Length: 15m
Width: 50mm
Direct heat resistance: 1800F / 1150 degree Celsius
Intermittent heat resistance: 2500F / 1400 degree Celsius
Colour: titanium -
Technical Information:
– 80°C thermostat
– 3/4unf oil filter thread
– 1/2bsp pipe fittings
– Seals included -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
Set of 8 Followers INA for 1.9 & 2.0 8v TDI Engines
-
This Racingline screw-in style billet fuel cap is all about detailing, representing stylish detail for your car, that’s a great replacement for the oem plastic cap !
-Direct bolt on
-T6061 aluminium CNC
-Gloss black anodised -
Monitor your 0-60mph, 60-130mph, 100-200kmh, 1/4 mile, 1/2 mile performance, and more!
-
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
This Racingline Performance wheel studs and nuts kit allows you to replace the factory bolts for a stud and nut system. This kit, besides having a more modern esthetic, will makes wheels swap for track or winter much easier and faster than using OEM bolts.
-
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
Installed high: 30 mm
Valve lift: 11,0mm
Hardness kp: 94 -
Electronic device oriented to the VAG vehicle market. It allows you to visualize the most important engine parameters in your vehicle without need any software or computer connected in real time. Plug Polar FIS device easily, get the control and start to monitorize everything.
-
This kit replaces the OEM bolt system with a higher tensile ARP stud and nut solution. Studs and nuts are regarded to be more reliable for clamping pressures over a conventional bolt.
-
Genuine Firad Nozzles for VAG for 1.9 / 2.0 8V PD Engines
-
The latest iteration of GFB’s feature-packed electronic boost controller now has the ability to monitor and display your engine’s air/fuel ratio in either Lambda or AFR. By connecting the analogue output of most wideband O2 controllers (i.e. Innovate LC-2, AEM UEGO etc, sold separately) to the G-Force III’s auxiliary input, you can toggle between boost pressure and air/fuel ratio display. Not only does this save you from having to install a separate AFR gauge in your car, it can also save your engine!
-
The PROTRACK ONE is one of the lightest TÜV approved cast wheels on the market. The perfect rim for the hot hatches.
-
A stainless steel silencer with a built-in damper
Can height / width – 130×220 mm
Valve type – Electric Inlet
Showing 1–50 of 59 results