Latest Products
-
WALBRO MOTORSPORT E85 FUEL PUMP - 450 L/H
€ 182.00 TAX included
-
ALPHA COMPETITION INLET HOSE FOR AUDI S3 8V / TT 8S / GOLF 7 GTI / R / LEON 5F CUPRA
€ 64.99 TAX included
-
RM MOTORS TRANSVERSE STRAIGHT-THROUGH SUPER FLOW PERFORMANCE MUFFLER
€ 219.00 – € 227.80 TAX included
-
WATER PUMP, ENGINE COOLING THERMAL MANAGEMENT MODULE FOR AUDI S3 8V / TT 8S / GOLF 7 GTI / GOLF 7 R / LEON 5F CUPRA 1.8/2.0 TSI EA888.3 MQB
€ 350.00 TAX included
-
TIMING CHAIN KIT FOR 2.0 TFSI EA113
€ 130.00 TAX included
-
- Street Comfort
Products to improve driving and operating comfort - Street Performance
Coilovers for an individual look and to improve driving dynamics on the road - Track Performance
Clubsport & racing suspensions to achieve the fastest possible lap time
For quotation please fill the budget form on our webshop.
- Street Comfort
-
ST Coilover Kits enable you to individually adjust the ride height of your car to improve the appearance and driving behavior. Depending on your selection, ST coilover kits offer a wide range of adjustments giving you the tools needed to dial them in to your requirements.
For quotation please fill the budget form on our webshop.
-
ap coilover kits offer the possibility to adjust drivers the desired lowering accurate to a millimeter for the sporty ambitioned driver. ap offer sporty handling and ideal performance in combination with the maximium lowering.
For quotation please fill the budget form on our webshop.
-
Length: 100mm
Aplication: Radiator / Coolant / Air / Water
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC -
Length: 1000mm
Aplication: Vaccum Lines & Coolant Overflow
Reinforcement: None
Temperature Rated: -60ºC to +180ºC
Material: Peroxide Cured 70 Shore Silicone -
Length: 100mm
Aplication: Radiator / Coolant / Air Hose / Water
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC -
Length: 100mm
Aplication: Radiator / Coolant / Air Hose / Water
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC -
Length: 100mm
Aplication: Radiator / Coolant / Air Hose
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC -
Internal Diameter: 60mm
Length: 100mm
Aplication: Radiator / Coolant / Air Hose
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
This Racingline Performance magnetic oil drain plug will protect your engine from the increased of metal particles into your oil pan by catching them via the magnetic section situated at the end of the plug
-
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
70mm to 51mm
Length: 100mm
Aplication: Radiator / Coolant / Air Hose / Water
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC -
Length: 100mm
Aplication: Radiator / Coolant / Air Hose / Water
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC -
BMC Complete Washing Kit
(Detergent + Spray)
-
Stripping weight out of your track car? Prefer that clean, uncluttered look without the rear wiper? Then this Rear Wiper Delete kit is for you….
-
Dimensions:
– thickness: 12 mm;
– spaces between holes: 36 mm
– precision: 0.01 mm
– thread 2 x M6 -
Dimensions:
– thickness: 12mm;
– spaces between holes: 36 mm
– precision: 0.01mm
– thread 2 x M6 -
Dimensions:
– thickness: 12 mm;
– spaces between holes: 36 mm
– precision: 0.01 mm
– thread 2 x M6 -
Dimensions:
– thickness: 12 mm;
– spaces between holes: 36 mm
– precision: 0.01 mm
– thread 2 x M6 -
– Direct bolt on
– Built in micro cat
– 100% stainless steel
– Compatible with any O2 sensors
– 90° bent structure for better access -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
Sabelt seat sliding runners are made to fit Sabelt and Sparco seats directly and to allow sliding movement backwards and forwards.
-
Designed specifically for the performance enthusiast, Iridium IX offers extreme ignitability, improved throttle response and superior anti-fouling.
-
Reduce temperatures!
- Thermal insulation of manifold/exhaust components
- Reduces engine bay temperature
- 15m x 50mm width (1.6mm thick)
- Material : titanium finish fiberglass
-
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
The unit is mounted directly on the transmission. CSC releasers are used when the installation space is too small for a conventional clutch actuating system.
-
Technical features
- Panel
- Outside Width 127/217mm
- Outside Length 217mm
-
Technical Information:
Length: 15m
Width: 50mm
Direct heat resistance: 1800F / 1150 degree Celsius
Intermittent heat resistance: 2500F / 1400 degree Celsius
Colour: titanium -
Technical Information:
– 80°C thermostat
– 3/4unf oil filter thread
– 1/2bsp pipe fittings
– Seals included -
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
The support works by a brass support pushing against the input shaft to stop the parting of the two 4th gears. The preload of the support is adjustable and should be checked periodically.
-
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness -
- Mounting points – 2
- Uses original nuts/bolts for mounting unless supplied
-
This Racingline screw-in style billet fuel cap is all about detailing, representing stylish detail for your car, that’s a great replacement for the oem plastic cap !
-Direct bolt on
-T6061 aluminium CNC
-Gloss black anodised -
This Forge Motorsport blow off valve been engineered to remedy the failure issues experienced with the OEM valve but also to provide better performance with amazing discharge tone.
-
This Performance intake kit is designed to fit the Seat Ibiza 6L and Volkswagen Polo 9N3 GTI with the 1.8T engines and 70mm MAF Sensors. Years 2006 – 2009
-
Fix those pesky misfires on your Audi or Volkswagen by replacing your ignition coil packs with these red NGK push-in coils found on the Audi R8!
-
DV+ Diverter Valve (25mm Bosch diverter replacement)
-
This is a complete torque link (not an insert) The link has been tested on diesel applications but due to the inherent vibration characteristics of the diesel engine there may be a significant increase in transmitted vibration at low engine speeds in diesel applications.
-
Monitor your 0-60mph, 60-130mph, 100-200kmh, 1/4 mile, 1/2 mile performance, and more!
-
Fix those pesky misfires on your Audi or Volkswagen by replacing your ignition coil packs with these red NGK push-in coils found on the Audi R8!
-
This recirculation valve is fully customisable to fit your application with two uprated springs provided in the kit. Forge Motorsport’s improvement on the original valve has resulted in a compact and aesthetically pleasing design that is fully serviceable, unlike the OEM valve. Coupled with a unique piston design this is the fastest responding DV on the market allowing an improved throttle response.
-
This Racingline Performance wheel studs and nuts kit allows you to replace the factory bolts for a stud and nut system. This kit, besides having a more modern esthetic, will makes wheels swap for track or winter much easier and faster than using OEM bolts.
-
This Forge Motorsport turbo recirculation valve is the result of 25 years of experience and engineering expertise. The FMDV008PA version seen here has the benefit of a 90 degree vacuum port, that can be rotated to three different orientations. This is often the preference where either space is restricted, or the original fitment valve has a 90 degree connection, either on the valve or connecting hose.
-
This is a significant upgrade to the OEM gearbox mount. It is suitable for all manual transmissions and retains the original battery box fixing.
-
This right hand side mount is a direct replacement for the OEM hydraulic engine mount.
Showing 1–50 of 61 results