Showing all 26 results
For quotation please fill the budget form on our webshop.
ST Coilover Kits enable you to individually adjust the ride height of your car to improve the appearance and driving behavior. Depending on your selection, ST coilover kits offer a wide range of adjustments giving you the tools needed to dial them in to your requirements.
For quotation please fill the budget form on our webshop.
ap coilover kits offer the possibility to adjust drivers the desired lowering accurate to a millimeter for the sporty ambitioned driver. ap offer sporty handling and ideal performance in combination with the maximium lowering.
For quotation please fill the budget form on our webshop.
Length: 100mm
Aplication: Radiator / Coolant / Air / Water
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC
Length: 1000mm
Aplication: Vaccum Lines & Coolant Overflow
Reinforcement: None
Temperature Rated: -60ºC to +180ºC
Material: Peroxide Cured 70 Shore Silicone
Length: 100mm
Aplication: Radiator / Coolant / Air Hose / Water
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC
Length: 100mm
Aplication: Radiator / Coolant / Air Hose / Water
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC
Length: 100mm
Aplication: Radiator / Coolant / Air Hose
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC
Internal Diameter: 60mm
Length: 100mm
Aplication: Radiator / Coolant / Air Hose
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC
Due to this blanking plate the hot exhaust gases no longer reach the intake manifold. When the oil from the crankcase breather mixes up with the hot exhaust gases from the exhaust gas recirculation, it will creat a few millimeters thick oil soot film in the intake manifold to the EGR valve, reducing the port diameter significantly. This reduces engine power and increased fuel consumption.
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness
– Prolonged tyre life
– Improved performance
– Increase safety
– Greater cost-effectiveness
70mm to 51mm
Length: 100mm
Aplication: Radiator / Coolant / Air Hose / Water
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC
Length: 100mm
Aplication: Radiator / Coolant / Air Hose / Water
Reinforcement: Polyester
Temperature Rated: -60ºC to +180ºC
The Plug is designed to block the hole left in the inlet manifold of the N57 Engine when the swirl flaps are removed.
BMC Complete Washing Kit
(Detergent + Spray)
– Direct bolt on
– Built in micro cat
– 100% stainless steel
– Compatible with any O2 sensors
– 90° bent structure for better access
Sabelt seat sliding runners are made to fit Sabelt and Sparco seats directly and to allow sliding movement backwards and forwards.
Reduce temperatures!
Technical Information:
Length: 15m
Width: 50mm
Direct heat resistance: 1800F / 1150 degree Celsius
Intermittent heat resistance: 2500F / 1400 degree Celsius
Colour: titanium
Monitor your 0-60mph, 60-130mph, 100-200kmh, 1/4 mile, 1/2 mile performance, and more!
Downpipe BMW E70 N57, N57S
X5
30dx, 40dx
2009-2013
245, 306 bhp
Downpipe doesn’t match to the Euro 6 version with the SCR module (AdBlue).
Pipe diameter – 76 mm
Pipe diameter at the point of the connection with a middle section – 70 mm
The latest iteration of GFB’s feature-packed electronic boost controller now has the ability to monitor and display your engine’s air/fuel ratio in either Lambda or AFR. By connecting the analogue output of most wideband O2 controllers (i.e. Innovate LC-2, AEM UEGO etc, sold separately) to the G-Force III’s auxiliary input, you can toggle between boost pressure and air/fuel ratio display. Not only does this save you from having to install a separate AFR gauge in your car, it can also save your engine!
A stainless steel silencer with a built-in damper
Can height / width – 130×220 mm
Valve type – Electric Inlet
A stainless steel silencer with a built-in damper
Can height / width – 130×220 mm
Valve type – Vacuum
The WAGNER TUNING Competition Intercooler Kit for the BMW X5/X6 has the following core dimensions (535mm x 332mm x 150mm / stepped, 19,2L). The high performance intercooler core provides a 113,5% larger frontal area and 120% more volume compared to the stock mounted intercooler.